Functions and Features
Pressure Resistance:The parking lock can endure a declining force of 500kg without being damaged.
Self-locking:
When the parking lock is at locked or unlocked status, no one else can make permanent changing on the status except the user.
Sealing:
The IP protection level is 67, which can fully prevent dust from entering and avoid damages caused by water washing.
Manual control:
If the battery is short of power or out of service, manual control can be made by pulling/pressing the rocking arm of the parking lock, so that the battery can be conveniently taken out for recharging, replacement or maintenance.
Power Cut-off on Resistance:
The power shall be automatically switched off on external forces unaffordable in the lifting of the parking lock to protect the electrical motor from being damaged.
Power Shortage Indication:
When the power is too short to start the parking lock, the indication lamp on the parking lock will flicker for three times to remind the user of recharging the battery in time.
Alarming and Resetting on External Force:
If the rocking arm is forced to be lowered when lifting, with the action of the external force, the front/back angle of the rocking arm will be changed, the parking lock will alarm to remind the external force applier to remove external force or remind the managerial staff to make treatment. The rocking arm will reset automatically after 5~7 seconds.
Theft Protection:
The position of the foundation for parking lock and ground installation will be protected by a large external cover. The cover can only be opened by the user with the key to make theft protection.
Installation principle and method
Installation Principle:
A. Installation Position
• The vehicle shall not touch the parking lock when going in and out of the parking space.
• The parking lock is suggested to be installed in the middle of entrance of parking space.
B. Installation Site
• The lock is required to be installed on level and dry cement ground.
Installation Method:
A. Lift the rocking arm manually with hands, open the lock with key. Open the upper cover to install the lock.
B. Drill three holes (12mm of diameter and 50mm of depth) and install M8 expansion bolts on the ground according to the locations of three installation holes on the parking lock foundation.
C. Cover three foundation spacers on the expansion bolts, and then cover parking lock foundation, install and tighten the bolts to finish installation.
D. before using, set the battery on level position, insert the plug into the socket of the parking lock and solar panel, sort up the wires.
E. Install the upper cover. Keep the upper and lower fixed blocks joggling (hold the back of upper cover to push forward as indicated in the schematic). Then lock the upper cover. Install the upper cover and push forward, and then lock the upper cover
BATTERY INSTRUCTIONS
1. The battery shall be recharged before using the parking lock. The recharging time shall be controlled within 10 hours. The indicate light will turn green from red if the battery is fully charged.2. During the application, if the terminal voltage of the battery is lower than 6.2V (the working speed of the parking lock is lower than usual). Recharge the battery in case that the parking lock cannot work normally.
3. Do not try to dissemble the battery to avoid any danger; do not clean the battery with chemical water; if the battery shell is broken and sculpture acid touches the skin, rinse immediately with clean water.
Application Instruction
1. Press the remote button to lift or decline the parking lock rocker. Power-off protection will be made if the rocker is blocked to prevent the electrical motor from being damaged.2. If the remote is out of service or the battery storage is low, lifting/lowering of the parking lock can be made with manual.
REPAIRING AND MAINTENANCE
The power shortage indication lamp is out; the parking lock cannot work properly when pressing the button.A. Inspect whether the power plug is properly connected.
B. Inspect whether there’s any abnormal noise in the electrical motor.
C. Inspect whether the remote is short of power (The indication lamp is out)
D. Inspect whether there’s any distortion of the shape of parking lock.
